Yellowtec VIPdigital Getting started 2
VIPdigital 22.06.2004 Getting Started
Electrical connection
Connect VIPdigital to your local power supply. VIPdigital is equipped with a switched-mode power
supply unit and can be operated on 90 to 240 V AC without any transfer.
Always follow the local safety regulations! Also, read the safety information below!
Activation
Switch on the power supply of the unit, using the power switch on the back panel. The Function
Display briefly shows VIPdigital, followed by the version identification of the firmware loaded. Your
VIPdigital is now ready for operation.
Please note that VIPdigital can only be deenergized by the power switch on the rear side of the
unit! Disconnect the mains plug before opening the housing in each case!
Using Internal Presets
VIPdigital has a non-volatile memory and on power-up it restores the last operating status existing
prior to a deactivation.
If no SmartCard has been inserted, one of the three Preset Recall memories is active. This is signalled
by the corresponding LED above one of the black Preset Recall buttons, marked with numbers 1, 2
and 3.
First of all, make yourself familiar with the preset functions. Press the Preset Recall buttons to select
the three available presets directly. The active preset is shown by a LED above the respective button.
The upper line of the display shows “Internal Preset” and the number of the selected preset; its name
appears in the lower line.
Using SmartCard
Note: Part of what is described below can only be performed when using a SmartCard that has presets
stored on it. There are no presets stored on the YELLOWTEC SmartCard supplied with the unit.
Insert a YELLOWTEC SmartCard
into the card slot. Please make sure that the gray double arrow of
the card is on the top, pointing to the front to the unit (the chip is upside down).
Once the card has been inserted, the LED of the previous selected Preset Recall button will flash to
indicate that the SmartCard has been detected, but none of its presets were loaded.
The three Preset Recall buttons now allow an access to the three presets stored on the SmartCard.
Select one of the three card presets. The display will show the name of the card holder in the upper
line and the name of the preset below.
Once the SmartCard has been removed, the LED of the preset loaded last will flash to indicate a new
access to the internal preset. At this time, the preset loaded last by the SmartCard will be active.
Press one of the three buttons to load an internal preset.
(69 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern